Setting examples:
0~3599
= 0 second, the device will not wake up by itself.
3600~7199
= 3600 seconds, the device will wake up every 3600 seconds.
Ⅶ
.RESETTING
Reset procedure clears the motion sensor's memory, including Z-Wave
network controller information. To reset Motion sensor:
1) Power on the device,
2) Press and hold the Z button for more than 20 seconds,
3)
If holding time more than 20seconds, the LED indicator will keep on for 2 seconds, which
means resetting is complete.
NOTE
Use this procedure only in the event that the network primary controller is
missing or otherwise inoperable.
Ⅷ
.ADVANCED CONFIGURATION
Motion sensor offers a wide variety of advanced configuration settings. Below parameters can be
accessed from main controllers configuration interface.
Parameter NO. 12 MOTION SENSOR’S SENSITIVITY
The higher the value, the more sensitive the PIR sensor.
Available settings:
1-8
Default setting:
8
Parameter size:
1 [byte]
Parameter No.14 ENABLE/DISABLE BASIC SET COMMAND
Motion sensor can send BASIC SET command to nodes associated with group 2 when motion is
triggered.
0
– Disable.
1
– Enable.
Default setting:
0
Parameter size:
1 [byte]
