Remote Controller
User's Manual
HCT-2216/HCR-2216
6. OPERATING PROCESS
6. OPERATING PROCESS
6-1. Starting for Transmitter and Receiver
-. Check the condition with these steps.
1) Open the case of the receiver and turn no the Power Switch.
2) Pull the red EMS(Emergency Stop Switch) button at the bottom of the
transmitter, and turn on the Key Switch to the siren('I' position).
3) Push on each runction button th operating.
* When it pushed each button of the transmitter, the Power LED lamp blinks 3 time per
second at the Low Speed Mode, and blinks 6 times per second at the high Speed Mode.
WARNING
IN AN EMERGENCY, PUSH THE EMS (EMERGENCY STOP SWITCH0 BUTTON TO SHUT DOWN.
Operate after check the causes and remove them.
Operate after check the causes and remove them.
6-2. Operating for Transmitter and Receiver
Check the condition to follow the steps.
If you have trouble, see 8. maintenance and fix it.
Call to us if impossible to fix it.
1 Push the ‘U’ (Up) button on the transmitter.
2 Push the ‘D’ (Down) button on the transmitter.
3 Push the ‘S’ (South) button on the transmitter.
4 Push the ‘N’ (North) button on the transmitter.
5 Push the ‘E’ (East) button on the transmitter.
6 P
h th ‘W’ (W
t) b tt
th t
itt
The PWR lamp (green) on the
transmitter and the Relay's lamp
in the receiver blinks.
6 Push the ‘W’ (West) button on the transmitter.
WARNING
- Operating Only the Workers Being Trained as Operator’s Training Course.
- Take Checkup and Training Regularly.
B S
t O
t th Sh t
t Di t
d S
it th F i ht i L
k d i S f t
- Be Sure to Operate the Shortest Distance and See it the Freight is Locked in Safety.
- See what the Crane and the Transmitter Move the Same Direction.
- Never to Operate Out of Sight. (Be Sure to Operate in Sight of the Crane and the Freight.)
Hangil Control Co., Ltd
9
2008-09-24
