19
4. Maintenance
More details for maintenance see
《
Preventive maintenance schedule
》
.
8 hour (daily or every shift) check
1)
. Check le
aks: electrolyte, hydraulic
oil, brake fluid, coolant, oil in hydraulic
transmission gear box
.
Check if the engine, connector of
hydraulic pipe, radiator and driving
system are leakage or not. Do not use an
open flame to check level, or for leakage,
of fuel, electrolyte or cooling water.
△
!
Warning!
Don’t attempt to operate the truck if
leaked fuel is found through
pre-operational check. Correct the leak
before starting engine
2) Check appearance
Check the lamps and meters are normal
or not.
Check the tires, air pressure and bolts
are loose or not.
Check whether tires are damaged or
pressure of tires is normal or not.
3) Check fuel mass
The fuel level gauge is provided on
the indicator panel. Check that fuel level
is sufficient for the day’s work. The fuel
filler port is provided at the rear left
pillar of the overhead guard.
4
）
Engine oil level check
Caution
When checking the engine oil,
should let the forklift truck on the level
ground.
When check the engine oil, it is exact
when the engine is cool.
Remove the dipstick, clean the rod
and reinstall. Pull it out again and check
the oil level. The level should be within
the mark on the dipstick.
5) Check water level in the radiator
Inspect the small reservoir tank to
see the coolant level is between Min and
Max position when the engine is cool. If
there is no coolant any more in the
reservoir tank, please add some coolant to
radiator, its freezing point is -35
℃
,and
add sub-radiator to MAX position.
△
!
Warning!
When the water temperature of the
engine is higher than 70 degree, please do
not open the pressure cap of the radiator.
Loosen cap slowly to allow steam to
escape. After that, tighten cap securely. It
is good practice to use thick waste cloth
or the like when removing the cap. Avoid
putting on gloves, since you may get
burnt at your hand if hot water splashes
on it.
