21
when leaving the factory) or DOT3
brake oil.
8)
Head lamp check
Make sure that the head lamp is
lighting when the key is at
“
ON
”
position.
9)
Turn signal check
Make sure that the turn signal operates
properly by moving the turn signal lever.
10)
Hand brake check
drive truck slowly.
①
loosen hand brake lever, stop the
②
truck, and truck has no deviation.
11)
Back-up lamp and buzzer check
The back-up lamp comes on and
buzzer sounds when the shift lever or
directional control lever is placed in
reverse position.
12)
Turning
Operate the truck running slowly.
Turn the steering wheel to left and
right 3 round respectively.
Check that the steering forces are
equal in right and left.
13)
Horn
Press the horn button to make
certain the horn sounds is normal or not.
14)
Drivers seat adjustment
Make sure the driver’s seat is
properly located. If not properly, shift
the adjusting lever to back and move the
driver’s seat to a position which
provides easy access to all foot and hand
controls.
15)
Shift lever(s) check
Check the shift lever(s) for
looseness and operation for smooth.
16)
Lifting lever, tilting lever and
attachment lever check
Check the loading levers (for lift,
tilt and optional attachment) for
looseness and smooth operation.
Increase the rotate speed of engine ,
make certain that the lifting lever, tilting
lever and attachment lever
in good work
condition.
17)
Instruments and sensors
Make sure that hour meter, water
temperature indicator, oil temperature
indicator, transmission fluid sensor and
fuel sensor etc., properly.
18)
Brake pedal, inching pedal and
clutch pedal check
Drive truck slowly, press down brake
pedal, and brake lamp lights.
Drive truck slowly, press down
inching pedal, the speed of truck
becoming decrease, and press downward
more ,truck will be braked and stop
Check function of clutch pedal, see
page 5
《
clutch pedal
》
。
19)
Tire pressure
Turn the tire valve cap counter
clock-wise and move it. Using a tire
pressure gauge, measure the inflation
pressure, and adjusting it to the specified
pressure, if needed. After making sure
there is no sir leakage from the tire valve,
reinstall the cap. Check that each tire does
not get damaged at the tread surface or
side face or bending at the rim.
△
!
Warning!
Since the forklift truck needs tires
that have a high inflation pressure to
carry heavy loads, even a small bending
of rims or damage at the tread surface
could cause an accident.
