11
Step 4
Slide the elevator into position on the hinges. The elevator
should be tight against the hinge line. Also check that the
balance tab of the elevator does not bind at the stabilizer.
Use thin CA to soak each hinge, both top and bottom.
Allow the CA to fully cure before proceeding.
Note
: Do not use accelerator when installing
the hinges. The CA must be allowed to soak
into the hinge to provide the best bond
between the hinge and surrounding wood.
Step 5
Once the CA is fully cured, pull on the stabilizer and
elevator to make sure the hinges are secure.
Step 6
Move the elevator through its range of motion, both up
and down, to break in the hinges.
Step 7
Use three more hinges to attach the remaining elevator to
the stabilizer as shown.
Hinging the Control Surfaces
