38
Step 11
Drill.out.the.hole.in.the.servo.arm.using.a.5/64".
(mm).drill.bit.then.slide.the.wire.through.the.
outer.hole.in.the.rudder.servo.arm..Secure.
the.wire.using.a.nylon.wire.keeper.
Step 12
Repeat.Steps.4.through.11.for.the.elevator..
pushrod.installation.
Step 13
Use.a.5/64".(mm).drill.bit.to.drill.a.hole.in.the.throttle.
servo.arm..Attach.a.quick.connector.to.the.servo.
arm.using.quick.connector.washers.and.retainers.
Step 14
Center.the.throttle.stick.and.trim.with.both.the.
receiver.and.transmitter.on..Slide.the.throttle.
pushrod.through.the.connector.and.install.the.
throttle.servo.arm.in.the.neutral.position.
Step 15
Move.the.servo.to.the.throttle.closed.position.using.
the.radio.system..Manually.move.the.throttle.arm.
on.the.carburetor.to.the.closed.position..Use.a.3mm.
setscrew.to.secure.the.throttle.pushrod.wire.
Step 16
Check.the.movement.of.the.throttle.to.verify.there.
is.no.binding.at.either.low.or.high.throttle..If.
there.is,.make.the.necessary.adjustment.using.
the.radio.system.to.eliminate.any.binding..Install.
the.throttle.servo.arm.screw.when.complete.
Section 10: Radio Installation
Summary of Contents for F6F Hellcat 60 ARF
Page 43: ...43 Notes ...