Hangar 9 Beast 100, Assembly Manual

Page: 34 / 70

34
 Step 2
Canister mounts come preglued but silicone
supports are not in place. Cut (8) 9/16-inch
pieces of silicone tube and mount them
through the slots in the mounts.
 Step 3
Prepare the canisters and headers to slide in
the tunnel as follows.
1. Install the Teflon® coupler on the header.
2. Using a vice-grip slide both clamps on the
header.
3. Push the Teflon coupler on the canister
inlet and slide the clamp over it.
4. Push the Teflon coupler over the header
until there is 1/8- to 1/4-inch gap between the
header and canister. Since this might be a
little hard to do, use a heat gun and glove to
move the coupler over the header easier.
5. Slide the other clamp so it is in front of
the bump, towards the front of the plane. If
you install the clamp on the other side of the
bump, the canister will pull out in the air.
6. Install the canisters and use threadlock on
the bolts.