11
Section 3: Installing the Aileron Servos
Step 6
Locate the aileron Servo Lead Extension (18") (JRPA099)
and connect it to the aileron servo lead. Secure the
connectors by tying them in a knot or use a commercial
connector that prevents the servo lead connections from
becoming disconnected.
Hint
: It is always a good idea to secure the
servo connectors and servo extension together
to prevent the wires from becoming unplugged
inside the wing.
Step 7
Locate the preinstalled string in the servo hatch opening
and tie it to the servo lead extension connector. Locate the
other end of the string in the exit hole you uncovered in
Step 1 and carefully fish the servo lead and extension
through the wing.
Note
: Tape the servo extension connector to
the topside of the wing to prevent the
connector from slipping back into the wing
structure.
Step 8
Place the servo hatch assembly back into the opening
and check the fit. Once satisfied with the fit, measure in
from each corner 1/8" and using a 1/16" drill bit, drill
the four mounting screw holes through the hatch and
plywood tab underneath.
Step 7 photo
Step 7 photo
Step 5 photo
