15
Fasten each side of the strut to the mounts near your front axle. Place
(1) of
M
over (1) of
L
and insert into the side of
N
that has the clips
sticking up. Repeat 2x. Slide one of the combination
M, L
&
N
over the
end of the strut and line-up with the threaded mounting hole on your fork
near the front axle. Install the bolt into the threading a few turns with a
4mm hex wrench, but do not install it all of the way tight, just enough to
hold it in place. Repeat for the other side.
16
Center your fender over the front wheel. Check the spacing of the fender
around your tire. There should be no less than 12mm (½ inch) of space
between the tire and the inside of the fender at all points.
13
With your fingers, install (1) of the larger aluminum washers
I
on the
back side of the bolt going through the pre-installed tab on the fender
and the fork crown. Then with your fingers, install the nut
J
until finger-
tight. Holding the front side of the bolt with one of the 10mm wrenches,
tighten down the nut
J
with the other 10mm wrench (a small adjustable
wrench may also be used). Note: Make sure that the fender tab does not
press against your headset lower cup or bearing, interfering with your
steering. If needed, you may bend down the top of the fender tab to clear
the headset.
14
Install your front wheel into the fork. Make sure that the fender struts are
free and not between the wheel and the fork.
L
(6) SHORTER HEX
HEAD BOLTS
M
(6) SMALLER
WASHERS
N
(4) PINCH SLEEVES
I
(2) LARGER
ALUMINUM WASHERS
J
NUT
H I J
COME PRE-ASSEMBLED
NOTE:
