H&S 4112, Operator'S Manual

Page: 22 / 32

-20-
LUBRICATION GUIDE
GREASE FITTINGS
There numerous grease fittings on the rake. If equipped with a center kicker wheel, there will be one
more on the pivot point. Lubricating properly and often enough will prolong the life of your rake. Grease
daily during normal use and
before and after storage and after power washing. Use a good grade of
high-quality grease. Make sure that grease comes out around the shaft on sleeve-type bearings. Wipe off
excessive grease to prevent accumulation of chaff or grit around the bearing.
Location
Listed and shown are the description of location and number of grease fittings.
A. (2) Top Opening Arm Front Pivot
B. (2) One on Each Gauge Wheel
C. (2) One on Each Lift Cylinder Mounting Bracket
D. (2) One on Each Rake Beam Pivot
E. (6) Top Rear Windrow Width Adjustment
F. (5) Top Opening Arm Rear Pivot
G. (1) Center Kicker Wheel Pivots (If Equipped)
(4) One on Each Transport Wheel Hub (4 on BF12HC and 6 on BF14HC)
(12) One on Each Rake Arm Hub (BF12HC Only)
D
D E E G D
C F B A F