-27-
Shields Removed for Clarity
LUBRICATION
H
E
C
A
D
B
F-G
I-J
GREASE ZERK LOCATION - Grease every 10 Hours
NOTE:
Shields removed in some pictures for clarity.
DO NOT OPERATE WITH SHIELDS REMOVED.
WHEEL BEARING LUBRICATION, CLEAN & REPACK INSTRUCTIONS
Wheel hubs are equipped with a grease zerk for regular maintenance. Annually disassemble and clean
parts in solvent. Reassemble bearings per instructions in the Service Chapter and tighten the castellated
nut on the spindle to the point where there is no end-play and a slight drag on the bearings. Replace the
cotter key with a new one of the correct size, bend cotter pin over and reinstall cap.
O
I. (2) Axle Pivot (Model 3231)
J.
(4) Axle Pivot (Model 3237/3243)
K.
(1) Beater Clutch Control Yoke
L.
(1) Two Speed Clutch Control Yoke
M.
(1) Two Speed Clutch Throwout
N.
(1) Rear Support Bearing
O.
(4) Zerks on hubs (1 on each hub)
P.
(2) Upper Beater
A.
(3) PTO Shaft
B.
(2) Front jack shaft bearings.
C.
(2) Rear Drive Shaft
D.
(1) Beater
E.
(2) Worm Drive Gearbox
F.
(4) Side Shaft (Models 3237/3243)
G.
(3) Side Shaft (Model 3231)
H.
(2) Tailgate Arms
P
K
N
L
M
Summary of Contents for 3243
