H&S 2208, Operator'S Manual

Page: 22 / 32

-20-
GREASE FITTINGS
There are numerous grease fittings on the rake as illustrated below. Lubricating properly and often enough
will prolong the life of your rake. Grease daily during normal use, before and after storage, and after power
washing. Use a good grade of high-quality grease. Make sure that grease comes out around the shaft
on sleeve-type bearings. Wipe off excessive grease to prevent accumulation of chaff or grit around the
bearing. Replace any missing or plugged grease fittings.
Become familiar with all lubrication points and establish a routine to ensure complete
lubrication of the rake.
GENERAL INFORMATION
IMPORTANT:
Catch and dispose of fluid per local waste disposal regulations whenever service is performed
on hydraulic components, valves, cylinders, hoses, etc.
WHEEL BEARING LUBRICATION, CLEAN & REPACK INSTRUCTIONS
Grease wheel bearings as needed depending on amount of travel.
Annually disassemble and clean parts in a solvent. Pack bearings
with a high grade grease. Reassemble, and tighten nut until a slight
drag is felt when wheel is turned. Back nut off and insert cotter pin
into the first hole that you see as you back the nut off. Bend the cotter
pin over and reinstall cap.
LUBRICATION
LOCATION
Listed and shown are the description of location and number of grease fittings.
1 zerk on jack
1 zerk on each
rake wheel hub
assembly
1 zerk on
each of the
adjuster pivot
points