H&S 2208, Operator'S Manual

Page: 19 / 32

-17-
OPERATION & ADJUSTMENTS
EMERGENCY SHUTDOWN
Stop the tractor engine, remove ignition key, and allow all mechanisms to stop before
cleaning or working on the machine.
IMPORTANT:
Retighten all bolts on the rake after 100 acres as bolts can loosen up on new machinery.
Re-torque rake tooth bolts after first 100 acres. Check periodically thereafter.
10 & 12-WHEEL WINDROW
WIDTH ADJUSTMENT
To set the windrow width adjustment for the
rake arm, follow the steps below:
1. Raise the rake beam so that the rake
wheels are slightly off the ground.
2. Remove the pin and hair pin clip from the
rake arm.
3. Manually slide the round beam to the
desired position.
4. Reinsert the pin in the desired hole and
replace the hair pin clip.
RAKING WIDTH
ADJUSTMENT
There are multiple width adjust-
ments on the wheel rake beam
for setting the windrow width.
Place the pin in the hole to
optmize windrow size.
Each rake beam angle can
be adjusted independently
for multiple raking conditions.
Keeping the raking width
adjustment in the front no wider
than the crop minimizes rake
wear as the wheel rolls easier
over the ground.
USE THE FOLLOWING STEPS BELOW TO SET YOUR RAKING WIDTH