16B Red Wing Lathe & Chuk/Changer Instruction
1
PARTS AND ACCESSORIES
PARTS LIST:
Below is a list of parts and accessories for the RED WING and most other Bench Lathes.
No.1
Special collet for burrs and all 3/32” tools
No.1A
A 3/32” burr adapter
No.1B
A 1/8” burr adapter
No.1C
A 3mm burr adapter
No.2
Pop-out spring
No.3
Stop (state length)
.265, .275, .285, .295, .305, .315
No.3S
Set of 6 stops (one of each length)
(use shortest stop possible that will still
allow the tools to slip into the master collet)
(the life of a worn collet may be extended by
using a shorter stop)
No.4
Stop lock screw
No.5
Master collet - should be cleaned and lightly
greased every 60 days
No.6
Special collet, complete with pop-out spring
and .275 stop
No.7
Clutch spring (Note: If Chuk/Changer Wells
Type is used on left side, please state for left
side)
No.8
Collet wrench
No.9H
Handle with plastic cushion grip
No.9HS Safety strap
No.10RW Clutch complete for all Red Wing lathes
No.10B Clutch complete for all Baldor lathes
No.10RM Clutch complete with bearing for all
Robbins-Myers lathes
No.10R Clutch complete with bearing
for all Ritter lathes
No.ADRW
Adapter for all Red Wing Lathes
No.ADB300
Adapter for all Baldor lathes
No.ADB221 Adapter for all Baldor 221-240 series
lathes
No.ADB210 Adapter for all Baldor 210-211
series lathes
No.ADRM Adapter for all Robbins-Myers lathes
No.ADRC Adapter for all Ritter C lathes
No.ADRC Adapter for all Ritter C lathes
No.ADRA Adapter for all Ritter A lathes
No.11
Clutch lining
No.12
Clutch lining screws (set of 3)
No.13
3/32” Hex wrench
No.14
Sandpaper chuck
No.15
Arbor band chuck 3/4” diameter
No.16
Sprial chuck
No.17
Field sandpaper chuck
No.18
Arbor for burrs
No.19
Stone chuck for tooth and knife stones, etc
No.20
Stainless steel mandrels with 1-64 screw
for heatless wheels etc
No.20S Screw only, 1-64 screw for No.20
No.21H Stainless steel mandrels with 2/64 screw
for 1-1/2” cutoff wheels
No.21HS Screw only, 2-64 for No. 21H
No.22
Bearings
