Marinator MCR011
Power Requirements
Insert the Plug of the MCR011 into a standard 120VAC, 60 Hz, 15A
or 20A outlet
All electrically operated appliances must be electrically
grounded in accordance with local codes, or in the
absence of local codes, with National Electric Code,
ANSI/NFPA No. 70-1990.
Initial Setup
1. Remove all paper from the equipment
2. Wipe clean with a damp cloth
3. Place Marinator as close to the UHC as possible
4. Plug unit into 120VAC, 60 Hz, 15A or 20A outlet
Calibration Check
1. Plug Marinator into an appropriate power source
2. Fill Marinator with fresh water up to the level mark
3. Place the empty stainless steel pan and lid into the
Marinator
4. Set power switch to the ON position
5. Preheat Marinator for one hour
6. Use a digital thermometer to measure the temperature of
the water. Insert the digital thermometer probe into the water.
If the water temperature is between 155°F and 165°F, no
adjustment is necessary. If the water temperature is under
155°F, or over 165°F, then the thermostat will need to be
adjusted.
CAUTION! Equipment and water contents are hot. Use breakfast
cart to transport the Marinator to the sink area
NOTE! Use necessary precautions such as gloves to handle the Marinator
when hot or let it cool before handling.
Operation Procedures
Setup:
1. Plug power cord into the appropriate power source
2. Fill the water pan with warm water up to the water level mark on
the ends of the pan
3. Install a 1/3 size stainless steel pan 6” deep
4. Cover the pan with the lid. Place the power switch in the ON
position. The switch will light up.
5. Allow the Marinator to warm up for 60 minutes before placing food
product inside.
Close:
1. Place the power switch in the OFF position
2. Unplug the Marinator
3. Remove the lid and the 1/3 size pan
4. Empty the water from the pan
5. Using a clean damp cloth towel, wipe down the water pan
6. Using a hot solution of MCD All Purpose Concrete (APC) from the
sink proportioner and a warm solution of MCD sanitizer, wash and
sanitize the lid and pan and set aside to air dry overnight
7. Store the Marinator in the designated area
CAUTION! Do not immerse Marinator in water. This will damage the
Marinator and void the warranty
Revision (B)
