Handife N1F-260E/20, User Manual

Page: 14 / 68

Press the side pushlock buttons of the battery pack as shown in Fig. 7 and push the battery pack
into the mount provided. When the battery pack is positioned as in Fig. 8, make sure that the
pushlock buttons latch in place! To remove the battery pack, proceed in reverse order.
5.7 Installing the battery (Fig. 8/9)
1.Take the battery pack out of the equipment. Do this by pressing the side push lock buttons.
2.Check that your mains voltage is the same as that marked on the rating plate of the battery
charger. Insert the power plug of the charger (10) into the socket outlet. The green LED will then
begin to light.
3.Insert the battery pack (11) into the battery charger (10).then the red LED on charger will begin
to light
4.In the section entitled “Charger indicator” you will find a table with an explanation of the LED
indicator on the charger.
5.8 Charging the battery (Fig. 10)
Voltage at the power socket
Whether there is good contact at the charging contacts.
If the battery pack still fails to charge, send the charging unit and the battery pack to our customer
service center.
To ensure that the battery pack provides long service, you should take care to recharge it
promptly. You must recharge the battery pack when you notice that the power of the cordless
vacuum drops. Never allow the battery pack to become fully discharged. This will cause it to
develop a defect.
The battery pack can become a little warm during the charging.
This is normal.
If the battery pack fails to charge, check:
Press the switch for the battery capacity indicator (Fig.11/Item C). The battery capacity indicator
shows the charge status of the battery using 3 LEDs (Fig.11/Item D) as following:
5.9 Battery capacity indicator (Fig. 11)
The battery is fully charged.
All 3 LEDs are lit:
The battery has an adequate remaining charge.
2 LED(s) are lit:
The battery will be empty soon, please recharge the battery.
1 LED is lit:
EN-8