Clearence hole for safety pin
To be able to mount and dismount the lift unit from the rail with the QuickTrolleySystem, the saftey pin, marked red in
fig 1, needs a clearence hole in the rail that enables the saftey pin to slide up and down. Mounting and dismounting the
lift unit from the rail will only be possible at the position where the clearence hole has been made.
I. Decide where on the rail the lift unit can be mounted and dismounted. NOTE! Distance, D in fig 2, from end of rail to
trolley depends on which end stop that is used, Table 1.
II. Drill a hole, diameter 10-12 mm, in the rail where the safety pin should slide up and down, fig 3.
III. Remove metal chips from the rail.
VI. Put the accompanying label on the rail to show the user where the lift unit can be mounted and dismounted, fig 4.
Fig 1; Safety pin
Fig 3; Trolley in rail
Trolley quick release
Trolley_new_design_2
WEIGHT: 3643.85
Material <not specified>
A3
SHEET 1 OF 1
SCALE:1:10
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE
SIGNATURE
NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
Fig 2; Trolley in position for mount-
ing / dismounting
Trolley quick release
Trolley_new_design_2
WEIGHT: 3643.85
Material <not specified>
A3
SHEET 1 OF 1
SCALE:1:5
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE
SIGNATURE
NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
Fig 4; Label on rail
Place the safety pin in the intended position in between the
charger plates, fig 1. The length of the safety pin chosen
depends on the height of the rail, Table 2.
Height of rail
Safety pin
H64
Short safety pin
M3x15 mm
H120 – H160
Long safety pin
M3x25 mm
Table 2; Length of safety pin
End stop used
Distance, D
Stop bult
50 mm
Adjustable end
stop
120 mm
Table 1; End stop
D
Skena med vagn
WEIGHT:
A3
SHEET 1 OF 1
SCALE:1:10
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE
SIGNATURE
NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
Safety pin
Assembly of the trolley
5
M A N U A L
System
RoMedic
TM
