9
M A N U A L
System
RoMedic
TM
Hand control
Raising/lowering the lift arm
Symbol indicate direction of travel.
Motion stops as soon as the button is released.
If the lift arm encounter an obstacle while lowering, the lift will
immediately stop the motion. In order to continue, the lift arm will
need to be raised slightly by using the hand control before further
lowering.
Widening/narrowing the base
Markings on the buttons indicate function.
Motion stops as soon as the buttons are released.
Service information read-out
Basic service information can be read out on the display. To get the service information on the
display please press the lifting arm up button for half a second. The information will be shown
for ½ minute or until other buttons are activated.
•
Total cycles done by the actuator
•
Total work done by the actuator (ampere usage times seconds in use)
•
Total number of overloads
•
Days since last service/Days between services
Battery information on the display
The battery discharging will be shown in four stages:
Battery state 1
: The battery is ok, no need for charging (100 - 50 %).
Battery state 2
: Battery needs charging. (50 - 25 %)
Battery state 3:
Battery needs charging. (Less than 25 %) A tone sounds when a button is pressed in
this battery state.
Battery state 4
: The battery needs charging (17V or lower). At this stage some of the functionality of
the lift is lost. At this battery stage it is only possible to drive the lifting arm down. Furthermore an
audio signal will sound when a control button is activated. The symbol will switch between the two
pictures for 10 seconds.
The battery symbol is shown when the box is active until power down (2 minutes after use).
It is not possible to use other batttery types than BAJ1/BAJ2.
The battery level is measured via voltage level. This means that it is possible to experience e.g. that
the battery switches from state 1 to state 2 and back to state 1.
English
Summary of Contents for MiniLift125
Page 2: ......
