12
Your scooter may be equipped with one of two light packages.
A / FRONT AND REAR RUNNING LIGHTS
1.
To turn on the front headlight and the rear taillights, push the
ON/OFF indicator pad, located on the speed control console.
2.
To turn the lights off, push the ON/OFF indicator pad again.
B / FRONT AND REAR TURN SIGNAL LIGHTS
(Handicare installed option only.)
Left turn signal indicators:
(front & rear) press the signal indicator on the left side of the console face.
Right turn signal indicators:
(front & rear) press the turn signal indicator on the right side of the console
face.
Hazard signal:
To activate all four signal lights at once, press both the left and the right signal pads and
hold for two seconds. Repeat to de-activate.
CIRCUIT BREAKER
Located on the top corner of the controller cover is a circuit breaker/cut-out
fuse. This circuit breaker protrudes out of the rear cover for easy access.
Major malfunctions or overloads will trigger the fuse. If the scooter has lost
power, check whether the automatic cut-out fuse has been triggered. Press
button downward to reset if necessary.
If it has been triggered, it will prevent the scooter from further operation. To
re-start the scooter after the cut-out fuse has been reset, you must pull out the
key from the receptacle to re-set the system. If the breaker immediately
triggers again, you may have to wait to give the motor time to cool off.
Subsequently, if the breaker resets, take care to drive slowly and steadily,
avoiding steep obstacles and/or hills as much as possible.
Note: If the breaker continues to trigger after the motor has cooled down, there could be a malfunction or
overload somewhere in the electrical system. Please contact your dealer for assistance should this occur.
LIGHTS
CIRCUIT BREAKER
