10
HANDLING AND LOADING
The seat should be carried by grabbing the frame below the seat back and the front of the seat upholstery.
Use both hands to grab the floor pan to carry the front section. Use the tiller release lever to fold the tiller in
the lowest position.
Grab the rear bumper with one hand and the other side of the rear frame with the other hand to carry the rear
section.
The batteries should be carried in the carrying straps.
When placing the disassembled scooter in a vehicle, make sure that the brake lever on the rear section is in
the brake “Engaged” position. Once the front section is loaded, the batteries can be replaced in the battery
recesses and buckled down. If there is not enough room in the trunk for the seat, it can be placed on the back
seat of the vehicle. Place it upside down on the armrests.
ASSEMBLY PROCEDURE
To re-assemble the scooter, reverse the steps outlined above making sure that:
•
The rear frame is resting on the rear bumper when the hooking rods are placed into the “J” hooks.
•
The locking mechanism and the latch lever are properly engaged.
•
The batteries are properly secured with the hold down straps.
•
All electrical connections are secure.
DISASSEMBLING / ASSEMBLING (cont.)
If your scooter can fit assembled into a vehicle, DO NOT use scooter as a passenger seat in a
transporting vehicle. It is not designed to restrain you during an impact of an automobile accident.
