Operating instructions
13
As a default, the wheelchair is in the intermediate position. If you wish to raise or lower the seat height, carry out the following steps
(see Figure 2 on page 12; the instructions are the same for all 3 models):
1. Remove the seat from the seat frame.
2. Remove the bolts from the front of the hinge plate (both left and right).
3. Unscrew the rear bolts (both left and right), but do not remove these as yet.
4. Tilt the hinge plate to the desired position and replace the front bolts into the holes (both left and right), but do not tighten these
as yet.
5. Remove the rear bolts (both left and right).
6. Tilt the hinge plate to the desired position and replace the rear bolts into the holes (both left and right).
7. Tighten all bolts securely and make sure that the washers are in place between the hinge plate and the main frame.
8. Readjust the tilting angle to the desired position (see tilting angle below)
Tilting angle 0-14 degrees
spider with spring clip
lock nut B
Allen bolt A
Figure 3
1. Unscrew the Allen bolt A (see Figure 3 above) a few twists (both left and right).
2. Unscrew the lock nut B (both left and right).
3. Remove the spring clip from the left-hand side spider.
4. Click loose the left-hand side spider.
5. Turn until the desired length is achieved.
6. Remove the spring clip from the right-hand side spider.
7. Click loose the right-hand side spider and click on the left-hand side spider.
8. Turn until the desired length is achieved.
9. Click the right-hand side spider back on.
10. Replace both spring clips.
11. Tighten both lock nuts.
12. Tighten both Allen bolts.
Seating depth (continuously adjustable)
back sliding part
Allen bolt A with lock nut B
*mounting point seat belt
Figure 4
1. Unscrew the lock nut B on both sides a half a turn, see Figure 4 above.
2. Unscrew the 2 bolts A (on both sides) one turn.
3. Move the back sliding part to the desired position
4. Tighten both bolts A (both left and right). Tighten the lock nuts B.
