Hand Held Products DOLPHIN 7600, User Manual

Page: 72 / 108

7 - 16 Rev B Dolphin® 7600 Series User’s Guide
WEP Encryption Without 802.1X Authentication
1. Double-tap the Client icon on the command bar .
2. On the Main Window (see page 7-3), tap the port and select Configure on the popup menu.
3. On the Wireless Networks Tab (see page 7-7), select the SSID in the list of Configured Networks and tap Properties .
(You may have to move the SSID from the list of Available Networks to the list of Configured Networks or add the SSID.)
4. On the Profile Info Tab (see page 7-9), select Do active scan .
(This is necessary only if the SSID is not broadcasting its SSID.)
5. On the WEP Mgmt Tab (see page 7-10), select Use key for data encryption .
If the AP uses Shared authentication, also select Use key to authenticate .
If the AP uses Open authentication, leave it unselected.
6. Enter the WEP Key ; see Key on page 7-19. Tap OK .
7. On the main window, tap Client > Restart to restart the Client.
8. Wait as the Client connects.
9. When the connection is complete, the Port Status Icon (see page 7-3) on the main window reads Associated instead of
Authenticated . However, the log file (see Logging on page 7-14) will read “Entered AUTHENTICATED state” when
recording this event.
Associating With Open APs
To associate with open APs means to set up the 802.11b/g radio without authentication or encryption.
1. Double-tap the Client icon on the command bar .
2. On the Main Window (see page 7-3), tap on the port and select Configure on the popup menu.
3. On the Wireless Networks Tab (see page 7-7), select the SSID in the list of Configured Networks and tap Properties .
(You may have to move the SSID from the list of Available Networks to the list of Configured Networks or add the SSID.)
4. On the Profile Info Tab (see page 7-9), enter your AP's SSID in the Network Profile field.
5. Select default in the Authentication profile drop-down list.
6. On the WEP Mgmt Tab (see page 7-10), make sure none of the options are selected. Tap OK ,
7. Tap OK on the Wireless Networks tab.
8. On the Main Window (see page 7-3), tap Client > Restart to restart the client.
9. Wait as the Client connects.
10. When connection is complete, the Port Status Icon (see page 7-3) turns yellow and the Status Bar (see page 7-5) reads
“Associated”.
Note: If DHCP service is not enabled on the network, then a static IP address and subnet mask would need to be entered
manually.