41
Starting
MAINTENANCE
Carry out the following measures before performing maintenance.
Before performing maintenance work on the appliance, disconnect the power cord and the water
supply.
Clean the water filter regularly. Remove the filter with a small pair of pliers and rinse it under
running water.
Clean the spray head under running water and clean the nozzle if necessary with the supplied
cleaning needle. Keep the appliance clean so that the cooling air can circulate freely.
Only use original spare parts from the supplier for repairs. If the machine is to be stored where
there is a risk of frost, or if it is to be stored for more than 3 months, antifreeze (as used in cars)
must be drawn into the appliance.
After start-up, there may be minor leakage from the pump, which will cease after a couple of hours.
Approx. 10 drips per minute is normal. If the leakage is greater than this, contact the supplier.
The electric motor is fitted with overcurrent protection. If this has been tripped, wait for 5-10
minutes before restarting the appliance. If the problem persists, see the troubleshooting chart or
contact your supplier.
Check the fuel filter regularly (1 in the figure below). Replace the filter if it is damaged or dirty.
Replace the fuel line if it is damaged.
