39
4.
Connect the high-pressure hose to the
intended outlet. Press the high-pressure
connection down fully and tighten without
using any tools.
5.
Connect the spray gun to the hose using
two spanners.
6.
Open the tap. The water temperature must
be below 40°C.
IMPORTANT!
The water must be completely
clean. Otherwise the machine will be damaged.
7.
Remove the handle lock, press in the spray
handle and spray
until all air has
disappeared.
8.
Fit the spray head to the spray gun.
9.
Connect the power cable.
10.
To start the appliance, press the spray
handle and activate the power switch
simultaneously.
11.
Fill the tank with fuel as indicated on the
data plate.
NOTE:
Never operate the machine with an empty
tank. This will damage the fuel pump. The correct
fuel must always be used. If it is not, this
represents a safety risk.
12.
Fill the detergent tank with a suitable
detergent (for high pressure washer).
WARNING!
Only liquid detergent may be used.
The detergent must not contain acid or be too
alkaline. Only use detergent that is intended for
high pressure washer.
Starting
Press the start button and allow the machine to run for a few minutes so that the air bubbles disappear.
Then stop the machine.
When the machine is restarted, check that the jet is even. If it is not, the nozzle must be cleaned. Then
wait for a few seconds until the pressure has risen, and open and close the handle 2-3 times. To use hot
water, activate switch (8). The burner is activated when the machine is under pressure. To mix in
detergent, open the regulator to the required amount, see below.
