6
Care and Cleaning
Troubleshooting
□
Use a dry, soft cloth to dust or wipe carefully.
□
Do not clean with abrasive materials, bleach, or solvents.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
LIGHTING PARTNERS JAX, INC. 3723 Regent Boulevard, Jacksonville, FL 32224. Phone: 904-642-4340.
Problem
Possible Cause
Solution
The lights will not turn on.
The bulb is burned out.
Replace the light bulb.
The power is off.
Ensure the power supply is turned on.
The cord is not plugged in.
Ensure the cord is plugged into an outlet.
The circuit breaker is off.
Ensure the circuit breaker is set in the “ON” position.
The fuse blows, or the circuit breaker
trips, when the light is turned on.
There is an exposed wire.
Discontinue use of the lamp. Unplug the unit from the wall.
Contact a qualified electrician or call the Customer Service
Team at 1-855-HD-HAMPTON.
