7
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Installation
1
Attaching Hanger Bracket Assembly
and Decorative Cap
2
Attaching Fan Head to Hanger
Bracket Assembly
WARNING:
WARNING:
Ensure the hanging structure can support a
WARNING:
Make sure the ceiling angle is not steeper than
□
With the cupped side down, push up the decorative cap (B) to
top of the hanger bracket assembly (A) through the cap hole.
to persons, turn off power to wall switch or make sure the
pull chain switch in off position before beginning installation.
30 degrees and the open end of the mounting bracket (not
included) is up and facing the ceiling, if angle mounting is
adopted for the fan.
minimum weight of 65 lb and allow enough depth for safety
mounting. If you are not sure the hanging structure can
support the weight, do not attempt to install this fan as it
may fall and cause damage to the fan or personal injury.
A
B
CC
A
A
CC
AA
AA
C
C
D
BB
□
Install the clevis pin (BB) througn the holes in the mounting
collar (C) and the hanger bracket assembly (A) and then secure
it with the hitch pin (AA). Retighten the lock screws (CC).
□
Pull out the hitch pin (AA) and then remove the clevis pin (BB)
from the mounting collar (C) of fan head (D). Loosen the lock
screws (CC).
□
Insert the hanger bracket assembly (A) into the mounting
collar (C) and then rotate clockwise to make sure the hole at
the bottom of the hanger bracket assembly (A) aligns with
the hole in the mounting collar (C).
BB