5
Assembly
2
Assembling the swivel base
and setting the chair frame on it
3
Tightening the nuts to the bolts
□
The four metal plates (CC) must be installed in the proper
location. Read this step and carefully examine the diagrams in
steps 2 and 3.
□
Place a metal plate (CC) on the topside of the “U” bar (1),
aligning the holes in the metal plate (CC), with the holes in
the “U” bar (1), through the holes in the rocker plate (HH) and
then, most importantly, through another metal plate (CC)
which must be placed directly beneath the rocker plate (HH).
□
Add a spring washer (BB) and a nut (DD) to each bolt. Hand
tighten the nuts 3-4 revolutions only.
□
Repeat the same procedure on the other side.
1
Preparing the swivel base
□
Place the swivel base (B) on a flat, solid surface.
□
Ensure the rocker portion of the swivel base (B) is positioned
all the way into the swivel base (B). It may have shifted or
vibrated out during shipment.
□
Note the arrow labels on the “U” bar (1) and the rocker
assembly. Also note the horseshoe shape of the rocker plate
(HH).
□
Point the open end of the horseshoe away from you.
□
The arrows on the rocker assembly shound be pointing
towards you.
□
Set the chair frame on the rocker assembly with the front of
the seat facing you and the arrows on the “U” bar (1)
pointing towards you.
□
If the chair frame has been properly positioned on the rocker
assembly, all arrows on the “U” bar and rocker assembly will
be pointing in the same direction.
B
A
EE
1
BB
DD
CC
CC
HH
AA
1
CAUTION:
Failure to place metal plates under rocker plates and above the rocker plates exactly as shown in diagram
will cause the bolt heads and nuts to damage the structure of the rocker plates. Damage due to over tightening of
bolts or improper assembly could cause injury and may void your warranty.
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
