5
Assembly
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
2
Assembling the leg connector bracket
3
Tightening the nuts to the bolts
□
Use the hex bolt driver (GG) and hex wrench (FF) to tighten all
nuts (BB) and bolts (AA). (Do not over tighten. Over tightening
may strip bolts.)
□
Cover all nuts (BB) and bolts (AA) with covers.
1
Assembling the table legs
□
Place the tabletop (A) up-side down on a flat, solid surface.
□
Attach the table leg (C) to the tabletop (A) by using the
bolts (AA) and washers (CC) as shown in the diagram.
□
Guide the bolts (AA) through the holes in the table leg (C),
and into the pre-drilled holes in the tabletop (A).
□
Hand tighten three to four turns only. (Do not tighten
completely. Some adjustments may be necessary to ensure
proper alignment of the table legs.)
□
Repeat for the other three legs.
□
Attach a leg (C) to the leg connector bracket (B) by carefully
guiding the bolts (AA) through the holes, in the leg (C)
connector bracket ( B).
□
Add a washer (CC) and a nut (BB) to the end of each bolt.
□
Hand tighten three to four turns only. (Do not tighten
completely.)
□
Repeat on the other three legs.
II (Preassembled)
A
DD
AA
CC
B
C
CC
BB
EE
