13
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Operation
1
Installing a gas tank
2
Checking for leaks
□
Open the drawer and place the 20 pound gas tank
on the tank support (G).
□
Secure the tank on the base by using the tank strap
(O). Attach the tank strap to the hook on the drawer
panel (H).
□
Attach the fire bowl to the gas tank with the hose
from the fire bowl.
□
Close the drawer (H).
NOTE: To operate, you will need a standard 20
pound propane tank.
WARNING: Follow all leak-checking procedures
before operating. To prevent fire or explosion
hazard when testing for a leak:
Always perform a leak test before lighting the
outdoor fire pit table and each time the tank is
connected for use.
No smoking. Do not use or permit any possible
sources of ignition in the area while conducting
a leak test.
Conduct the leak test outdoors in a well-
ventilated area.
Do not use matches, lighters, or a flame to
check for leaks.
Do not use the outdoor fire pit table until any
and all leaks are corrected.
If you are unable to stop a leak, disconnect the LP
gas supply. Call a gas appliance serviceman or
your local LP gas company.
□
Mix two to three ounces of a soapy solution to check
for leaks. Use one part liquid dishwashing detergent
and three parts water.
□
Apply several drops of solution where the hose
attaches to the regulator.
□
Apply several drops of solution where the regulator
connects to the cylinder.
□
Make sure all fire pit and ignition valves are off.
□
Turn the cylinder valve on.
□
If any soap bubbles are visible where the solution has
been applied, the connections must be tightened
another turn and the leak check must be performed
again.
NOTE: If burner fails to remain lit, close all
valves and wait 5 minutes before attempting to
light the fire pit again.
