the end of hanger pin until it snaps into its
locked position as noted in the circle inset
of Figure 7.
6. Retighten the set screws on the collar on top
of the motor housing.
7. Make sure the grommet is properly installed
in the lower collar cover, then slide thecol-
lar cover (upper and lower) on the downrod
until they set on the motor housing. Be sure
that the canopy and the collar covers are
both oriented correctly.
8. Proceed to “Installing the Fan” section.
5.
“Close-to-Ceiling” Mounting
1. Remove the canopy ring from the canopy
by turning the ring to the right until it
unlocks (Figure 5).
2. Remove the mounting plate from the cano-
py by loosening the four screws on the top
of the canopy. Remove the two non-slotted
screws and loosen the slotted screws. This
FAILURE TO COMPLETELY TIGHTEN THE
THREE SCREWS IN STEP 7 COULD RESULT IN
THE FAN LOOSENING AND POSSIBLY FALLING.
FAILURE TO PROPERLY INSTALL THE LOCK-
ING PIN AS NOTED IN STEP 5 COULD RESULT
IN FAN LOOSENING AND POSSIBLY FALLING.
Figure 8
Figure 9
Figure 10
will enable you to remove the mounting
plate (Figure 6).
3. Remove the decorative canopy bottom cov-
er from the canopy by depressing the three
studs (Figure 8).
4. Remove three of the six screws and lock-
washers (every other one) securing the mo-
tor collar to the top of the fan motor housing
(Figure 9).
5. Place the rubber gasket over the remaining
three screws, route the wires exiting the top
of the fan motor through the canopy ring
(make sure the slot opening are on top),
then proceed to place the ceiling canopy
over the collar at the top of the motor.
(Figure 10).
6. Align the mounting holes with the holes
in the motor and fasten, using the three
screws and lock-washers removed in step 4
(Figure 10).
7. Tighten the mounting screws securely.
Summary of Contents for Renwick
Page 1: ......
