10
Assembly - Attaching the Fan Blades
Assembly - Attaching the Switch Cup
Attaching the switch cup
Attaching the blades to the blade
brackets
Fastening the blade assemblies to
the motor
10
8
9
□
Attach a blade (H) to a blade bracket (G) by inserting screws
(AA) into the holes in the blade and through the blade
bracket. Note that the rubber washers are preattached to
the blade bracket.
□
Tighten each screw securely.
□
Repeat these steps for each blade (H) and blade bracket (G).
□
Fasten the blade assembly to the fan-motor housing (D) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the blade bracket screws (TT). The blade
bracket screws (TT) are pre-installed into the blade bracket (G).
□
Repeat this step for the remaining blade assemblies.
AA
H
G
D
G
TT
CAUTION:
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
D
E
GG
IMPORTANT:
Remove the rubber stopper on the black bracket
below the motor in order to attach the blade assembly to
the motor. Replace the rubber stopper to prevent water from
entering the switch housing and to reduce the risk of fire,
electric shock, or other personal injury.
□
Remove the four screws on the switch cup (E).
□
Connect the wires exiting the bottom of the black bracket
with the switch cup by connecting the molded adaptor
connectors together.
□
Secure the switch cup (E) to the black bracket using the four
screws that were removed in the first step above.
□
Attach the pull chain extension (GG) to the fan pull chain.
