Tuck connections neatly into ceiling outlet
box.
Slide the canopy up to mounting bracket and
place the key hole on the canopy over the
screw on the mounting bracket, turn canopy
until it locks in place at the narrow section of
the key holes. (Fig. 12)
Align the circular hole on canopy with the
remaining hole on the mounting bracket,
secure by tightening the two set screws.
Note:
Adjust the canopy screws as necessary until the
canopy and canopy cover are snug.
1.
2.
3.
Install 4 x 15W bulbs (provided) into the
sockets of the top plate on the top of motor
(Fig. 13).
Remove 1 of the 4 screws from the glass
housing and keep it for future use. Loosen the
other 3 screws. (Do not remove). Hold up the
top glass housing to ceiling fan assembly. Get
through the three screws on glass housing into
the three key holes located on the bottom of
motor housing, twist clockwise to set glass
housing firmly with motor housing. Secure by
tightening the 3 screws previously loosened
and the one previously removed. (Fig. 13)
1.
2.
Finishing the Fan
Installation
WARNING
MAKE SURE THE TAB ON THE MOUNTING
BRACKET PROPERLY SITS IN THE GROOVE IN
THE HANGER BALL BEFORE ATTACHING THE
CANOPY TO THE BRACKET BY TURNING THE
HOUSING UNTIL IT DROPS INTO PLACE.
8
Attaching the Top Glass
Housing
Motor Housing
Top Glass
Housing
Screws
Figure 13
Figure 12
Outlet Box
Ceiling
Mounting
Bracket
Screw
Screw
Canopy
Canopy
Bottom Cover
E12/15W
Bulbs
Top Plate
Summary of Contents for Miramar
Page 2: ...Miramar por Hampton Bay ...
