4
Assembly and Installation (continued)
7
Installing into a wall
8
Connecting the wires
□
When the wall is being built, the hardscape adaptor (C) can be built into
the wall as illustrated below.
WARNING:
The wire connector (D) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION:
The wire from low voltage power unit should be 12-16
AWG type underground low Energy Circuit Cable.
IMPORTANT:
□
Protect the wiring by routing it in close proximity to the light
fitting, or next to a building structure such as a house or a
deck.
□
The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
□
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
Place the wire connector (D) on opposite sides of the low voltage
cable (not included) from the transformer (not included) where the
fixture will be located.
□
Align and fit the main low voltage cable vertically to the slot of the
wire connector (D).
□
Press the wire connector (D) together until it is locked around the
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
□
Once the wire connector (D) is in place, it is recommended to wrap
it with electrical tape (not included).
□
After all fixtures are installed, turn on the transformer.
