1
Use and Care Guide
LOW VOLTAGE LED POST LIGHT
PACKAGE CONTENTS
A – Post Light x 1 B–Male Plug x 1 (with 60 in. wire) C –Large
Adaptor x 1 AA – Self-Threading Screw (30 mm) x 2
D – Small
Adaptor x 1 E – Wire Connector (with 39 in. wire) x 1 F –Female Plug x 1 BB – Plastic Anchor (25 mm) x 2
Assembly and Installation
1
Select the appropriate adaptor
2
Installing the post light on the post when the
wire behind the post
Post light with small adaptor:
□
The post light (A) comes pre-attached to the small hardscape adaptor
(D). If you select the small adaptor, you can directly install it in the next
step.
Post light with large adaptor:
□
Use a screwdriver (sold separately) to press in the button (1), and then
pull the post light (A) up by hand.
□
Place the post light (A) over the large adaptor (C), until the button (1)
insert to the hole of the post light (A).
NOTE
: There have a plastic gasket around each button (1). Please do
not remove the plastic gasket when replacing the adapter.
□
Use at least a 7/16 in. drill bit to drill a hole on the mounting
surface large enough for the male plug (B) to pass through the
hole on the mounting surface.
□
Insert the male plug (B) through the hole on the mounting
surface.
□
Insert the male plug (B) into the female plug (F).
□
Place the adaptor (C/D) over the top of the post, use a pencil
(sold separately) to gently mark the location of the two holes
on the wall.
□
Remove the adaptor (C/D) from the post. Use a drill to bore two
5 mm deep holes in the wall, placing the holes following the
location of the two holes on the adaptor (C/D).
□
Insert the plastic anchors (BB) into the holes on the wall, screw
the self-threading screws (AA) into the plastic anchors (BB) to
fix the adaptor (C/D) on the post.
Item # 1008 540 723
Model # HSP1801LX-02/MB
Item # 1008 540 729
Model # HSP1801LX-02/ZC
