ASSEMBLY INSTRUCTIONS (AS SHOWN IN DIAGRAM):
1.
Make sure the main power to the circuit is OFF.
2.
Install mounting bracket to existing outlet box with screws(
A
).
3.
Pull wires through mounting bracket hole.
4. ELECTRICAL CONNECTIONS (B):
a.
Connect the white wire(s) from the fixture to the white wire of the supply
circuit.
b.
Connect the black wire(s) from the fixture to the black wire of the supply
circuit.
c.
Connect the green colored (or bare copper) wire to the grounding conductor
of the supply circuit.
d.
Use U.L. Listed wire connectors suitable for the size, type and number of
conductors. No loose strands or loose wires should be present.
e.
Secure wire connectors with U.L. Listed electrical tape.
f. Carefully tuck connected wires back into the outlet box.
5. Secure the canopy by threading the nut onto the mounting bracket stem. Place the
decorative nut onto the end of the mounting bracket stem(
C
) (Adjust the length of
the stem when necessary).
RELAMPING THE BULB (D)
1. Make sure that the power is turned off.
2.
THE BULB IS HOT!
Make sure that the bulb is cool before re-lamping the
fixture.
3.
Remove and replace the bulb using the re-lamping tool(
E
).
4.
Restore electrical power.
CAUTION: Do not exceed the recommended maximum fixture wattage.
ASSEMBLY DIAGRAM
3
