7
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Routing the wires
Assembling the fan
Preparing for standard mounting
□
Loosen, but do not remove, the setscrews (HH) on the collar
on top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (E).
□
Carefully inset the hanger pin (CC) through the holes in the
collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews (HH) on the collar on top of the
fan-motor assembly (E).
□
Remove the canopy bottom cover (OO) from the canopy (C) by
turning the bottom cover counterclockwise until it unlocks.
□
Loosen the two canopy screws (SS) located in the bottom of
themounting bracket (A), and turn the canopy counterclock-
wise to remove the mounting bracket (A) from canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (II).
□
Make sure the opening of canopy (C) is on top and insert the
ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
3
1
WARNING:
Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
Assembly - Standard Ceiling Mount
C
II
E
B
D
C
A
SS
OO
C
II
E
B
D
CC
DD
HH
