HAMPTON BAY HOLLIS 52196, Use And Care Manual

Page: 11 / 15

11
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Mounting the fan-motor assembly
□
Align the locking slots of canopy (C) with the two screws
(GG) and alignment post (QQ) in the mounting bracket (A).
□
Push up the canopy (C) and turn clockwise until the align-
ment post (QQ) engages the round hole and the screws (GG)
engage to the key slots.
□
Firmly tighten the two mounting screws (GG). Install the
decorative bottom cover (HH) by aligning the covers slots
with screws in the bottom of the canopy (C). Rotate the bot-
tom cover clockwise to lock in place.
7
WARNING:
When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
Assembly - Hanging the Fan (continued)
Attaching the blade brackets to
the motor
Attaching the blades
1 2
□
Mount the fan blade (F) to the blade bracket (G) by aligning
the three key-slot holes in the blade (F) with the three posts
on the top of the blade bracket (G).
□
Hold the blade (F) with both hands close to the blade bracket
(G) and press the blade (F) down firmly. Ensure the key-slot
holes are properly seated on the blade bracket (G) posts.
□
While still holding the blade (F) down with both hands, firmly
slide the blade (F) away from the fan-motor (D) housing until
the blade (F) engages in the locking mechanism. Make sure
the steel locking mechanism at the rear of the blade bracket
(G) springs upward and butts against the edge of the blade
(F), indicating a secure connection.
□
Visually inspect the top of the blade bracket (G) to ensure the
locking mechanism is securely in place.
□
Repeat this procedure for the remaining blades (F).
NOTE:
Your fan features revolutionary advancements for
quick and easy blade installation.
NOTE:
Your fan blades are reversible. Select the blade side
finish which best accentuates your decor.
□
Fasten the blade bracket (G) to the fan-motor (E) by
inserting the alignment post into the slot on the bottom of
the fan-motor (E) and tightening the fan-motor screws.
□
The fan-motor screws are pre-attached to the blade
bracket (G). Repeat this procedure for the remaining four
blade brackets (G).
Assembly - Attaching the Fan Blades
C
A
GG
HH
B
E
QQ
E
G
QQ
F
G
SS
RR