8
Care and Cleaning
Ƒ
Use a dry cloth to clean the doorbell, sensor, and push buttons.
Ƒ
Do not use cleaners or polishes.
Ƒ
Do not use any fluids on the doorbell, sensor, and push buttons.
Troubleshooting
Problem
Possible Cause
Solution
Doorbell does not
sound.
Ƒ
Batteries not installed
correctly.
Ƒ
Make sure batteries are installed according to the
diagram inside the sensor and push buttons.
Ƒ
Batteries are dead.
Ƒ
Check the charge of the sensor and push button batter-
ies and replace if necessary.
Ƒ
Doorbell is not receiving
power.
Ƒ
Make sure the plug-in doorbell has power.
Ƒ
The doorbell and the
sensor or push buttons
are not synced.
Ƒ
Sync the doorbell to the sensor or push button(s). Only
one sensor or push button may be synced at a time.
Repeat these steps for each sensor or push button.
Ƒ
Press and hold the button on the doorbell until the
doorbell sounds a “Beep-Beep”.
Ƒ
Press the button on the side of the sensor or the
push button(s) within 30 seconds. The doorbell will
sound a “Beep-Beep” tone to indicate the sensor or
the push button(s) is synced.
Ƒ
Rotate the sensor as shown in step 4 under Installa-
tion or press the push button(s) to ensure operation.
