8
To Light
To Extinguish
Before performing a leak test, be sure that no sparks can occur and you a re in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “o ff”
position. Brush a soap and water mixtur e on all connections. Turn the gas supply on; if bubbles
occur on any connection the re may be a leak. If you smell gas or a leak is discove red tu rn the
gas valve o ff, disconnect p ropane gas tank and do not use the appliance until the leak is
repaired.
Do not use the heating unit without inspecting the gas hose. If the re are signs of wear or abrasion
you must replace the hose (if applicable).
Pumice stones/lava rocks/LavaGlass
could pop up and
20 minutes after igniting. Flame height should be a yellow/blue color between 2 - 10 inches in height.
heating item.
1. Make sure the control knob (F) is in the “off” position. Slowly open the valve on the p ropane gas
tank by turning the knob counte rclockwise.
2. Push and hold in the electronic ignit r (G) to create sparks within the elect rode, continue to hold.
3. Push in the control knob (F) and turn to the “low” position. Keep holding down the cont rol knob
5 seconds.
4. If ignition doesn’t occur within a few seconds , release the control knob (F) and rotate to the “OFF”
position. Wait for 5 minutes for gas to clear and then repeat the above lighting instructions.
5.
between the “low” and “high” positions.
1. Turn control knob (F) clockwise to the “low” posi
the control knob (F) to the “off” position.
2. Close the cylinder valve on the propane gas tank if you don ’t intend to use it for a long time.
OPERATION
Fire product and p ropane gas cylinder minimum
distance must be over 60 inches (as per right side
photo)
WARNING
60”
tion; let the knob pop up and continue turning
Summary of Contents for GFHD48
Page 12: ...12...
