Installing the Light Kit 10.
Reverse
switch
Switch
housing
Wire
connector
Screws
Bulbs
Pull chain
and fob
Glass shade
Figure 18
N O T E
: B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is
not sufficient to prevent electric shock.
1. Remove the stainless steel plug from the
switch housing cover (Fig. 17), attach the
light kit to the switch housing cover by
feeding the light kit wires (black and white)
through the hole of switch housing cover
and then screw it onto the switch housing
cover by nut & lock washer provided. Be
sure it is tight enough to prevent light kit
from vibrating loose.
NOTE:
Make sure
that the concave of the switch housing
cover and the pull chain holders are in an
angle of 90 degrees for pull chains go
through the pull chain holders easily. (Fig.
17)
2.
ocate two single white and blue
wires in the switch housing labeled FOR
L I G H T . M a k e t h e p o l a r i z e d p l u g
connections:
- White to white
- Blue to black
3. Carefully push all wires back into the switch
housing. Attach the light kit fitter by
aligning its keyhole slots with the three
screws holes and reversing switch on the
side of switch housing. Tighten the three
screws securely to prevent the light kit from
vibrating loose.(Fig. 18)
While holding the light kit assembly under
your fan, l
4. Pass the two pull chains on the switch
housing through the chain holders located
on the light fitter, install the fobs to the pull
chains. (Fig. 18)
5. Install two 60 watt (max.) bulbs (provided)
and glass shade with four thumb screws,
do not over tighten.
6. Restore power and your light kit is ready
for operation.
7. If the light kit does not work, turn off the
electricity and lower either canopy or
decorative housing on your ceiling fan to
make sure the blue wire is connected to the
black household wire.
Figure 17
NOTE:
Light bulbs have no warranty,
can be purchased at local light bulb
specialty store or from our service center.
Switch housing
cover
Concave
Light kit
o
90
Nut
Lock washer
Plug
Pull chain
holder
