HAMPTON BAY Fulton 140201, Owner'S Manual

Page: 10 / 29

8.
2. Connect the blue wire from the fan motor
to the black wire from the light kit assem-
bly by connecting the molded adaptor plug;
connect the white wire from the fan motor
to the white wire from the light kit assembly
by connecting the molded adaptor plug.
3. Secure the light kit assembly to the black
bracket using the three screws and lock-
washers that were removed in step 1.
4. Remove the three mounting screws on the
side of the light kit assembly (Figure 13).
Installing the Light Kit
and Glass Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing light kit.
1. Remove the three mounting screws and
lockwashers on the black bracket below the
fan motor (Figure 12).
Figure 12
Figure 13
5. With power off, install the circline lamp
(Max. 30W, provided) to the lamp bracket
pre-assembled in the light kit assembly and
engage the connector from the ballast of the
light kit assembly with the 4-pins on the
circline lamp, make sure they are engaged
properly (Figure 13).
6. Install the glass bowl to the light kit assem-
bly and finger tighten with the three mount-
ing screws that were removed in step 4.
NOTE: PERIODICALLY CHECK THE
MOUNTING SCREWS HOLDING THE
GLASS ARE FIRMLY TIGHTENED AND
THE GLASS IS SECURE.