Care and Cleaning
CAUTION:
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
Use a dry or slightly dampened, clean cloth (use clean water, never use a solvent) to wipe the interior and exterior surfaces of the
8
Operation
Functional instruction
To save energy, the display will turn itself off after 20 seconds. Press any key to re-activate the display setting except the “RESET”
key.
This power pack retains the last setting of operation when the power pack is turned off.
After the problem is solved, press "
RESET
" key to reset the unit.
After properly installing the power pack, turn on the power pack.
There are four buttons for operation. Every time you press either button,
it will turn to another working mode. Push either button repeatedly to
move to the different selections.
“
O
n
/OF
” - MANUAL ON/OFF (lights stay on until manually turned off).
“
AU
” - ON AT DUSK OFF AT DAWN (lights turn on at dusk and
turn off at dawn).
“1”
through
“12”
- ON AT DUSK RUN TIME (lights turn on at
dusk and turn off after the selected number of hours).
“
EE
”- CHECK CIRCUIT. If this is displayed, power to the power pack has been
interrupted or too many lights have been installed. Immediately check the following:
Is the cable correctly inserted into the power pack terminals?
Is the unit overloaded or are the wires touching?
To test the photocell during the day, plug the power pack into a 120-volt covered GFCI outlet. Press the setting button to "
AU
",
making sure the photocell is completely covered, and the lighting will turn on. When you remove the back plastic cover from the
photocell, and the photocell senses direct sunlight, the light will turn off. The proper area for the power pack is an area where the
photo eye can sense direct sunlight. This is needed so the photo eye feature works properly. If the photo eye cannot sense direct
sunlight, then the lights may not turn on and off properly.
To restore the power pack to its original factory settings (Photocell Auto ON/OFF), press and hold the MANUAL ON/OFF button for 10
seconds until the display shows 88 and all the indicator lights are lit.
Cable Selection
Total Fixture Wattage
0-60 Watts
61-120 Watts
121-180 Watts
181-240 Watts
241-300 Watts
600W Transformer = (2X300) Watts
900W Transformer = (3X300) Watts
51-100 feet
Cable Length
101-150 feet
16 AWG
16 AWG
14 AWG
16 AWG
14 AWG
12 AWG
14 AWG
12 AWG
NOT RECOMMENDED
14 AWG
12 AWG
NOT RECOMMENDED
12 AWG
NOT RECOMMENDED
NOT RECOMMENDED
12 AWG
NOT RECOMMENDED NOT RECOMMENDED
12 AWG
NOT RECOMMENDED NOT RECOMMENDED
0-50 feet
12 VOLT TAP
