HAMPTON BAY CYPRUS 220 635, Owner'S Manual

Page: 11 / 30

8
with the 3 screws previously removed. Be
sure to tighten all screws. (Figure 20)
5. To install light kit glass shade, remove
the socket ring on the light kit and install
the glass shade to the light kit. Secure by
tightening the socket ring previously
removed. (Figure 21)
6. Install three E12*40W bulbs. (included)
7. Restore power and your light kit is ready
for operations.
Installing the Light Kit
CAUTION To Reduce The Risk Of
Electric Shock, Disconnect The Electrical
Supply Circuit To The Fan Before Installing
Light Kit.
REMEMBER The fan blades must already
be attached to the fan.
Your fan and light kit though pre-wired have
been disassembled at the factory to ease in
shipping. Please follow these steps to
complete the installation of your fan and
light.
TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
1.Remove 1 of 3 screws from the mounting
plate and loosen the other 2 screws(Do not
r e m o v e ) . P l a c e t h e k e y h o l e s f r o m t h e
compartment box cover over the 2 screws
previously loosened from the mounting plate,
turn compartment box cover until it locks in
place at the narrow section of the key holes.
Secure by tightening the 2 screws previously
l o o s e n e d a n d t h e o n e p r e v i o u s l y
removed.(Figure 19)
2.Remove 3 screws on compartment box
cover.(Figure 20)
3. While holding the light kit assembly under
your fan, snap together the wire connection
plug. (Figure 20)
4. Carefully push all wires back into the
compartment box, then install the light kit
assembly onto the compartment box cover
Figure 20
Figure 19
LIGHT BULBS HAVE NO WARRANTY, CAN
B E P U R C H A S E D AT L O C A L H O M E
IMPROVEMENT STORE OR FROM OUR
SERVICE CENTER.
NOTE:
Housing
Screw
Wire connection
plug
Compartment
box
Light kit
Compartment
box cover
Socket ring
Housing
E12 40W bulb
Figure 21
Mot or hous ing
mounting plate
Screw
Compartment box cover