4
Motor Collar
Hitch Pin
Lead Wires
Ball/downrod
Assembly
Ceiling
Canopy
Lock Pin
Couping cover
Tighten
Screws
Firmly
Canopy cover
Hanging the Fan
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
1.
3. Remove hanger ball from downrod assembly
by loosening set screw, removing the cross pin,
and sliding ball off rod. (Figure 7)
4. Carefully feed fan wires up through the
downrod. (Figure 8) Thread the rod into the
coupling. Next, line up holes and replace lock
pin and hitch pin. Tighten set screws.
5. Slip coupling cover, canopy cover and
canopy onto downrod. (Figure 9) Carefully
reinstall hanger ball onto downrod, make sure
that cross pin is in correct position, set screws
are tighten and wires are not twisted.
Secure the hanger bracket to the ceiling
outlet box with the screws and washers
provided with your outlet box. (Figure 5)
2. Remove the hitch pin and lock pin from
the downrod assembly. Loosen the two set
screws from
the motor assembly. (Figure
6)
6. Now lift motor assembly into position and place
hanger ball into hanger bracket. Rotate until the
check groove
should not rotate
if this is done correctly.
drops into the registration slot and
seats firmly. (Figure 10) Downrod
Figure 6
Downrod
Supply
wires
Figure 8
Figure 10
Registration
slot
Figure 5
Cross
pin
Hanger
ball
Downrod
Figure 7
Outlet
box
Hanger
bracket
Hitch
pin
Lock
pin
Set
screws
Figure 9
Summary of Contents for Cherokee 565 332
Page 1: ...Cherokee ...
