HAMPTON BAY Cherokee 565 332, Owner'S Manual

Page: 10 / 14

8
5. Carefully push all wires back into the
switch box , then install the light kit
assembly onto the switch box cover with the
3 screws previously removed. Be sure to
tighten all screws. (Figure 19)
Install 2
×13
W CFL (included).
7. Remove the rubber washer, metal nut,
metal cap and finial from the light kit
assembly. Place glass shade over the light kit
stem, secure with the rubber washer, metal
n u t , m e t a l c a p a n d f i n i a l p r e v i o u s l y
removed. Do not over tighten.
6. .
(Figure 20)
8. Restore power and your light kit is ready
for operations.
housing
screw
Figure 18
housing
screw
connection
plug
light kit
switch box
CFL
Figure 19
Mounting
ring
Switch
cover
Switch box cover
Figure 20
Finial
Metal Cap
Metal Nut
Rubber Washer
Glass shade
LIGHT BULB HAVE NO WARRANTY, CAN BE
P U R C H A S E D AT L O C A L L I G H T B U L B
SPECIALTY STORE OR FROM OUR SERVICE
CENTER.
NOTE
Installing the Light Kit
CAUTION To Reduce The Risk Of Electric
Shock, Disconnect The Electrical Supply
Circuit To The Fan Before Installing Light
Kit.
REMEMBER The fan blades must already
be attached to the fan.
Your fan and light kit though pre-wired have
been disassembled at the factory to ease in
shipping. Please follow these steps to
complete the installation of your fan and
light.
TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
1. Remove 1 of 3 screws on the mounting ring
and loosen other 2 screws. (Do not remove)
2. Tuck connections neatly into light kit.
Place the key holes on the switch cover over
the 2 screws previously loosened from the
mounting ring, turn switch cover until it locks
in place at the narrow section of the key holes.
Secure by tightening the 2 screws previously
loosened and the one previously removed.
(Figure 18 )
3. Remove one of 3 screws on compartment box.
(Figure 19)
4. While holding the light kit assembly under
your fan, snap together the wire connection
plugs. (Figure 19)