8.Installing the Mounting
Plate
NOTE: Before starting installation, disconnect the
power by turning off the circuit breaker or removing
the fuse at fuse box.
Step 1.Remove one of 3 screws and loosen other two
screws on the mounting ring. (Figure. 13)
Step 2. Remove the mounting plate from the light kit
by removing 4 screws (Keep them for future use).
Step 3.Place the key holes on the mounting plate over
the 2 screws previously loosened from the mounting
ring, turn mounting plate until it locks in place at the
narrow section of the key holes. Secure by tightening
2 screws previously loosened and the one previously
removed. (Figure. 13)
9.Installing the Light
Kit Assembly
N O T E :
L i g h t b u l b h a v e n o
warranty, can be purchased at
local light bulb specialty store or
from our service center.
Step 1. While holding the light kit
assembly under your fan, snap together
the connection plugs.(Figure 14)
Step 2. Carefully push all wires back into
the switch housing, then install the light
kit assembly onto the mounting plate with
4 screws previously removed in the
process of installing the mounting plate.
Be sure to tighten all screws. (Figure 14)
Step 3. Install 2
×6 0
W
candelabra bulbs
(included).
Step 4. I.nstall the glass shade, along
with rubber washer, metal washer, twist
with metal nut; install the cap, then twist
the finial tightly. (Figure 14 )
Step 5. Restore power and your light kit
is ready for operations.
NOTE: Make sure to leave enough space
between the fan pull chain and the bulbs
to the chain doesn’t rub against any of the
bulbs. Light bulbs have no warranty, they
can be purchased at local light bulb
specialty store or from our service center.
Screw
plate
mounting ring
mounting
Light kit
Screw
Figure 14
Light kit
Finial
Cap
Metal
Nut
Rubber
Washer
Metal
Washer
Bulb
Connection plugs
Screws
Mounting plate
Switch
housing
Summary of Contents for 855975
Page 1: ...48 ...
