4
INSTALLATION INSTRUCTIONS
(AS SHOWN IN DIAGRAM):
INSTALLATION OF TRACK/CONNECTOR ASSEMBLY:
1. Determine which connector will be used to power track and attach.
2. Place track power feed connector assembly at desired location on ceiling, noting
location of electrical supply. Mark the ceiling through the holes in track and remove
track.
3. For toggle bolt installation, drill a 5/8in. hole at each mark on ceiling, insert bolts
through the track and thread toggles 1/2in. onto bolts.
4. Place track/connector assembly against ceiling and insert toggles into holes until the
spring open. Tighten bolts.
5. To connect two tracks, loosen set screws on straight connector, align grounds and insert
into track. Tighten set screws.
TROUBLE SHOOTING:
Problem Possible
Cause
Corrective
Action
1. Light bulb is burned
out.
1. Replace light bulb.
2. Power is off.
2. Make sure power supply is
on.
3. Faulty connection of
fixture to track or wire
connections.
3. Check connection of fixture
to track. Check wiring.
Light Bulb will not
illuminate.
4. Faulty switch.
4. Test or replace switch.
Fuse blows or circuit
breaker trips when light
bulb is illuminated.
Crossed wires or power
wire is grounding out.
Check wire connections.
Ceiling
Track
Dead end cap
Toggle bolt assy
