Lock ring
Bulbs
Glass shade
Screws
Light kit
assembly
Wire connection
plugs
N O T E
: B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
Turning power off using the fan switch is
not sufficient to prevent electric shock.
1. Attach the light kit to the switch housing
cover by feeding the light kit wires (black
and white) through the hole of switch
housing cover and then screw it onto the
switch housing cover by nut & lock washer.
Be sure it is tight enough to prevent light
kit from vibrating loose. (Fig. 16)
2.
Make the polarized plug
connections: (Fig. 17)
- White to white
- Blue to black
3. Carefully push all wires back into the
switch housing, then install the light kit
assembly onto the mounting plate with 3
screws provided. Be sure to tighten all
screws. (Fig. 17)
4. Remove the lock ring from the socket by
turning the lock ring counter-clockwise
Until it unlocks. Insert the glass into the
glass holder and turn the lock ring
clockwise to tighten the glass. Repeat for
the remaining glass. (Fig. 17)
While holding the light kit assembly under
your fan,
5. With the power off, insert the light bulbs
(included) into the light kit sockets.
Max. 40 watts.
6. Restore power and your light kit is ready
for operation.
NOTE:
When you tighten up the light kit,
be sure to align it so it will allow the pull
chain to drop free and clear.
Figure 17
10.
Installing the Light Kit
Figure 16
NOTE:
Light bulbs have no warranty,
can be purchased at local light bulb
specialty store or from our service center.
Switch housing
cover
Light kit
Nut
Lock washer
