5
Installing Fan to
the Electrical Box
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR OTHER PERSONAL INJURY.
MOUNT FAN ONLY TO AN OUTLET BOX OR
SUPPORTING SYSTEM MARKED ACCEPTABLE
FOR FAN SUPPORT AND USE THE MOUNTING
SCREWS PROVIDED WITH THE OUTLET BOX.
Pass the 120-volt supply wires through the
center hole in the hanger bracket as shown in
Figure 10.
Install the hanger bracket on the outlet box
with the screws and washers provided with
your outlet box. (Figure 10)
Security tighten the two mounting screws.
(Figure 10)
Carefully lift the fan assembly up to the hanger
bracket and seat the hanger ball in the hanger
bracket socket. Make sure the tab on the hanger
bracket socket is properly seated in the groove
in the hanger ball (Figure 11). This will help to
balance the ceiling fan.
1.
2.
3.
4.
Slip coupling cover, canopy cover and canopy
onto downrod. Carefully reinstall hanger ball
onto rod being sure that cross pin is in correct
position, set screws are tighten and wires are not
twisted. (Figure 9)
6.
Figure 10
UL Listed Outlet Box
Hanger Bracket
120V
Wires
Mounting
Screws
(Supplied
with Electrical Box)
Tab
WARNING
THE TAB IN THE RING MUST REST IN THE
GROOVE OF THE HANGER BALL AS FIGURE 8.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
Figure 11
Groove
Tab
Figure 9
Motor Wires
Ceiling Canopy
Canopy Bottom
Cover
Tighten Screw
Firmly
Ball/Downrod
Assembly
Coupling Cover
Clevis Pin
Cotter Pin
Pin in Locked
Positioon
