Model No.: 191-707
Vendor No.: 11289
UPC# 792145326670
REMOTE CONTROL INSTALLATION
GENERAL INFORMATION
This remote control is designed to separately control your ceiling fan speed and light brightness. There are four
buttons (Hi, Med, Low, off) to control the fan speed and off. The light dimmer button will control the light
brightness dimmer and off. The red indicator on the transmitter will light when the button is pressed.
1. SETTING THE CODE
This unit has 16 different code combinations. To set the code, perform
these steps:
A: Setting the code on the transmitter.
a. Remove battery cover. Press firmly below arrow and slide battery
cover off.
b. Slide code switches to your choice of up or down position.
(Factory setting is all up. Do not use this position. Use a small
screwdriver or ball point pen to slide firmly up or down (Fig. 1).
B: Setting the code on the receiver:
a. Slide code switches to the same positions as set on your transmitter
(Fig. 2).
b. Replace battery cover on transmitter.
2. INSTALLING RECEIVER IN CEILING FAN
A: Safety precautions:
WARNING: HIGH VOLTAGE! Disconnect source of electrical
power by removing fuse or switching off circuit breaker.
Do not use with solid state fans.
Electrical wiring must meet all local and national electrical code
requirements.
Electrical source and fan must be 115/120 volt, 60Hz. Maximum fan
motor amps: 1.0 Maximum light watts: 300-incandescent only.
Household electrical power can cause serious injury or death!
B: Installing receiver in fan:
a. Remove electrical power from the circuit.
b. Remove ceiling fan canopy from the mounting bracket.
c. Disconnection existing wiring between ceiling fan and supply at
electrical junction box.
d. Make connections as follows, using the wire nuts supplied:
CONNECT TO
Green fan wire…………………….Bare supply wire
Black receiver wire (AC IN L)……Black supply wire
White receiver wire (AC IN N)…...White supply wire
White receiver wire (TO MOTOR N)..White fan wire
Black receiver wire (TO MOTOR L)…Black fan wire
Blue receiver wire (FOR LIGHT)……..Blue light wire
If other fan or supply wires are different color, have this unit
installed by qualified licensed electrician.
e. Push all connected wires up into junction box.
f. Lay the black antenna wire on top of the receiver, and put the
receiver in the mounting bracket. (Fig. 4)
g. Reinstall all canopy on the mounting bracket
h. Restore electrical power.
3. OPERATING TRANSMITTER:
A. Install 9 volt battery (not included) (To prevent damage to transmitter
remove the battery if not use for long periods). (Fig. 5)
B. Store the transmitter away from excess heat or humidity.
C. This remote control unit is equipped with 16 code combinations. To
prevent possible interference from or to other remote units such as
garage door openers. Car alarm or security system. If you find that your
fan and light kit go on and off without using your remote control.
Simply change the combination code in your transmitter and receiver.
RECEIVER
AC SUPPLY
BLACK
WHITE
BARE
GREEN
WHITE
WHITE
BLUE
BLUE
BLACK
BLACK
RECEIVER
NOTE:
When installing the remote control, be sure your fan is operated in
"HIGH SPEED"
and light is in
"ON"
condition at the switch knob.
Fig. 1
Fig. 3
Fig. 4
Fig. 5
Fig. 2
TRANSMITTER
CODE SWITCHES
RECEIVER
ON
LIGHT
HI
OFF
MED
LOW
9V
BAT.
